Art-Tech R/C Hobby Bedienungsanleitung PDF herunterladen (Seite 14)

50mm

Inspection and adjustment before flying

1. Switch for power supply: Install 8 cells dry batteries in the transmitter according to the symbol of

battery’s polarity, then turn on the switch of power. Install the full charged battery into the foreside of

the fuselage, and connect the plug of battery with the electronic Speed Controller. To make sure the

radio control system working well, you should follow the instruction: turn on the switch of the

transmitter before flying (connecting the battery with ESC plug); and turn off the power for receiver

first when stop operation (pulling out battery and ESC plug), then turn off the transmitter.

2. The right joystick of transmitter controls the aileron by turning left or right: when you push the

joystick on the left, the left aileron of plane will turn up and the right aileron of plane will turn down in

response to your action, vice versa. Before flying, put the trim of aileron to the middle position, and

then adjust the both ailerons to neutral position by the steel wire grip.

3 The sway of the right joystick in the transmitter controls the power of motor. When holding the

fuselage of the plane, please keep other objects away from the propeller in case of hurting people or

destroy the propeller. If you push the right joystick in the lowest position, the power of the motor will

cease. Now the motor is on standby. You could check the performance of the motor by pushing the

joystick up slowly. If you want to cancel standby situation, you could take off battery plug.

4. The up and down of the left joystick of transmitter controls the movement of the elevator. When you

push the joystick down, the elevator of plane will be flying up, vice versa. The best state before

flying is the elevator, joysticks and inching switches are all in the neutral position.

5. The right joystick in transmitter control the rudder: when you push the joystick on the right, the

rudder of plane will turn right in response to your action, vice versa. Rudder, joystick trim should be

in the middle before flying.

6. If the servos and motor give no response during the adjustment, please check the connection of the

servos and ESC and make sure the battery is fully charged.

7. Check the CG of the glider in windless condition, the CG is near to the main wing, please refer to the

picture.

Note: The transmitter and receiver should be used in the same set but not be mixed and used with

other products.

1. Radio control distance should be tested before the airplane taking off. After loading the battery to the model

and transmitter, turn on the switch and keep the control distance about 200 meters between the transmitter

and the model.

2. Please turn on the transmitter before taking off the model. The indicator should be green. If it doesn’t, please

check if it has been connected well with the battery. If the indicator is red, change the battery.

3. Plug in the power supply, operate the joystick to see whether the movement of the control surface is normal

or not. Push the throttle to the lowest position and push it upwards gradually. The propeller will run very fast,

which causes big thrust and noise. Then the model can fly from the ground after running or you can throw it

off by hand.

Adjustment during the flying

(Picture for CG)

1 2 ... 9 10 11 12 13 14 15 16

Keine Kommentare

Art-Tech R/C Hobby Bedienungsanleitung Seite 14